Coala
Level: Roachling
Rank Points: 14
Registered: 06-26-2014
IP: Logged

Just before Christmas, I was playing around and thought I'd try building DROD on my 2Gb Raspberry Pi 4. This was actually relatively simple - meant adding architecture support to the builder process (ninjamaker), and to a single source file. These changes were mentioned in a couple of other forum posts here, but these seemed to target the Pi 3, rather than the Pi 4.

Anyway, the key, once those changes were made, was ensuring there was enough swap space to allow compilation - I used a 1Gb swap area and it worked fine, and you might be able to get away without it if your Pi has more memory.

This change has been merged and is available in the main branch! Enjoy!