Xindaris
Level: Smitemaster

Rank Points: 1809
Registered: 06-13-2015
IP: Logged

The below is some pretty standard "custom tar mother" code:


It works fine, but if I put a monster of this type down and put a "Replace with Default Script" command, then it bugs out. If a monster is set up that way, then the first time the player steps into the room it will work properly, but then if the player leaves the room and comes back it will no longer run the "tar control" part of the script at all. So it just stays at 0 hp forever and you can't cut the tarstuff anymore.

____________________________
109th Skywatcher

Here are some links to Things!

---

[Last edited by Xindaris at 09-06-2025 10:28 PM]

hyperme
Level: Smitemaster

Rank Points: 1606
Registered: 06-23-2006
IP: Logged

Good chance to laugh at me: when a script is replaced with the default script, the replacement doesn't get persisted. This is a big problem.

____________________________
[Insert witty comment here]
Qzvlkx?