Rabscuttle
Level: Smitemaster

Rank Points: 2460
Registered: 09-10-2004
IP: Logged

... doesn't work. (specifically, the PM link next to their name in the hold information section of the page.)

I get

ERROR!
You need to enter a username.

when I try to send. (PMing normally works)

---

[Last edited by Rabscuttle at 12-21-2006 11:31 AM]

Schik
Level: Legendary Smitemaster

Rank Points: 5381
Registered: 02-04-2003
IP: Logged

I can't reproduce this... does it happen for anyone else? Or is it for a specific architect that it doesn't work?

____________________________
The greatness of a nation and its moral progress can be judged by the way it treats its animals.
--Mahatma Gandhi

Rabscuttle
Level: Smitemaster

Rank Points: 2460
Registered: 09-10-2004
IP: Logged

Didn't work when I try to send a message to Pilchard VIII (from Slayers Revenge) or me (from Tar Ballroom). Same error in both cases.

---

[Last edited by Rabscuttle at 12-21-2006 10:20 PM]

Briareos
Level: Smitemaster

Rank Points: 3516
Registered: 08-07-2005
IP: Logged

Schik wrote:
I can't reproduce this... does it happen for anyone else? Or is it for a specific architect that it doesn't work?

Nah. The URL of the holds page PM link is just missing a "username=<your name>" parameter, even though your username is displayed correctly on the send page.

If I try to message myself and remove the "username=Briareos" parameter from the URL, I get the exact same error.

If I add it back again, I get the correct "Can't message yourself yadda yadda" error.

np: Pole - Lachen (1)

____________________________
"I'm not anti-anything, I'm anti-everything, it fits better." - Sole
R.I.P. Robert Feldhoff (1962-2009)